Front Disc Brake: Installation

WARNING: This page is about a different car, the 2012 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: Do not use an abrasive sanding disc since it will remove paint or other protective finishes from the wheel or metal from the mounting surfaces, adversely affecting corrosion protection and brake disc lateral runout.

Remove corrosion from the wheel mounting surfaces, both disc mounting surfaces and hub mounting surfaces.
- Use specified brake parts cleaner to clean the brake disc and hub surfaces.
- Apply specified anti-seize lubricant to the hub mounting surfaces to prevent future corrosion.
Install the brake disc.
2 Piston Caliper equipped vehicles

NOTE: Using specified brake cleaner, clean any residual threadlock compound from the anchor plate threads before installing the bolts.

Position the brake caliper, brake pads and anchor plate assembly.
- Install 2 new brake caliper anchor plate bolts and tighten to 115 Nm (85 lb-ft).
4 Piston Caliper equipped vehicles
Position the brake caliper assembly and install 2 new caliper bolts.
- Tighten the bolts to 115 Nm (85 lb-ft).