Section 2219 (Engine Cooling System)
WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnosis And Testing
- General Procedures
- Cooling System Draining, Filling and Bleeding
- Special Tool(s)
- Material
- Draining
- Filling and Bleeding with a Vacuum Cooling System Filler - Degas Bottle Systems
- Filling and Bleeding without a Vacuum Cooling System Filler - Degas Bottle Systems
- Filling and Bleeding with a Vacuum Cooling System Filler - Coolant Expansion Tank System
- Filling and Bleeding without a Vacuum Cooling System Filler - Coolant Expansion Tank Systems
- Cooling System Flushing
- Cooling System Draining, Filling and Bleeding
- Removal And Installation
- Block Heater
- Coolant Crossover Manifold Assembly - 3.5L GTDI
- Coolant Inlet Pipe - 3.5L GTDI
- Thermostat - 3.5L GTDI
- Thermostat Housing - 3.5L GTDI
- Thermostat - 3.7L
- Thermostat Housing - 3.7L
- Thermostat - 5.0L
- Thermostat Housing - 5.0L
- Thermostat - 6.2L
- Coolant Pump - 3.5L GTDI, 3.7L
- Coolant Pump - 5.0L
- Coolant Pump - 6.2L
- Cooling Module
- Special Tool(s)
- Hood Latch, Transmission Cooler Tubes, Power Steering Cooler Tubes (6.2L) and Cooling Module Bolts
- Wiring Harness and Power Steering Fluid Reservoir - 6.2L
- Wiring Harness - 3.5L Gasoline Turbocharged Direct Injection (GTDI), 3.7L and 5.0L
- Wiring Harness and Radiator Hose Retainers
- Cooling Fan Wiring
- A/C Fittings
- Radiator Hoses - 3.5L Gasoline Turbocharged Direct Injection (GTDI), 3.7L and 5.0L
- Radiator Hoses - 6.2L
- Removal
- Installation
- Cooling Fan Motor and Shroud
- Radiator
- Radiator Hose
- Coolant Expansion Tank - 6.2L
- Degas Bottle - 3.5L GTDI, 3.7L, 5.0L