Selector Lever: Installation

Install the selector lever and the 4 selector lever bolts.
- Tighten to 12 Nm (106 lb-in).
  
  Fig 1: Locating Selector Lever Bolts
  Courtesy of FORD MOTOR CO.
Connect the selector lever electrical connector.

Fig 2: Locating Selector Lever Electrical Connector
Courtesy of FORD MOTOR CO.
Install the selector lever cable on the selector lever housing.
- Be sure the tabs are locked in place.
  
  Fig 3: Locating Selector Lever Cable Tabs
  Courtesy of FORD MOTOR CO.
Connect the selector lever cable end on the selector lever ball stud.

Fig 4: Locating Selector Lever Cable End On Selector Lever Ball Stud
Courtesy of FORD MOTOR CO.
Install the selector lever bezel. For additional information, refer to SELECTOR LEVER BEZEL .
Check the selector lever cable adjustment. Make sure that the vehicle starts in PARK and NEUTRAL and the reverse lamps illuminate in REVERSE. If an adjustment is necessary, refer to SELECTOR LEVER CABLE ADJUSTMENT .