Programming the Autolock Feature Using the Door Lock Control Switch
NOTE:
The autolock feature can be activated or deactivated independently of the auto-unlock feature.
NOTE:
The autolock feature of the Smart Junction Box (SJB) can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to
MODULE CONFIGURATION
.
NOTE:
When programming the autolock feature using the door lock control switch method, the following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.
- Switch the ignition from the OFF to the RUN mode.
- Press the unlock button on the door lock control switch 3 times.
- Switch the ignition from the RUN to the OFF mode.
- Press the unlock button on the door lock control switch 3 times.
- Switch the ignition to the RUN mode. The horn chirps once to indicate that programming mode is entered.
- To enable/disable the autolock feature, press the unlock button on the door lock control switch, then the lock button. The horn chirps once if the autolocks are disabled or twice (one short chirp followed by a honk) if the autolocks are enabled.
- Switch the ignition to the OFF mode. The horn chirps once to signal that the programming is complete.
NOTE:
Prior to beginning, make sure the ignition is in the OFF mode and all vehicle doors are closed.