Removal And Installation: Resonator: Installation

Grind the spot weld and the tac weld from the Torca® clamp and remove the clamp.
Clean the uneven surface area and position the new Torca® clamp.

Fig 1: Locating Torca Clamp
Courtesy of FORD MOTOR CO.
Install the resonator with a new exhaust Y-pipe-to-resonator gasket and fasteners.
- Tighten to 40 Nm (30 lb-ft).

NOTE: Make sure the clamp position is no more than 27.5 mm (1.08 in) or less than 25.5 mm (1 in) from the inlet of the resonator pipe.

Fig 2: Locating Clamp And Button With Torque Specification

Courtesy of FORD MOTOR CO.

Make sure the back of the slot is covered by the clamp and the resonator button is fully seated inside the notch.
Tighten the Torca® clamp.
- Tighten to 55 Nm (41 lb-ft).