Selector Lever Cable Adjustment

Remove the Air Cleaner (ACL) and outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
Disconnect the selector lever cable end from the manual control lever.

Fig 1: Locating Selector Lever Cable End At Manual Control Lever
Courtesy of FORD MOTOR CO.
Place the selector lever in DRIVE.

Fig 2: Locating Selector Lever In Drive Position
Courtesy of FORD MOTOR CO.
Place the manual control lever in DRIVE.
1. Rotate the manual control lever clockwise until it stops.
2. Rotate the manual control lever counterclockwise one detent.
  
  Fig 3: Placing Manual Control Lever In DRIVE
  Courtesy of FORD MOTOR CO.
Unlock the adjuster by sliding the locking tab over.

Fig 4: Unlocking Adjuster By Sliding Locking Tab Over
Courtesy of FORD MOTOR CO.
Slide the selector lever cable end forward or backward to align it with the manual control lever.

Fig 5: Aligning Selector Lever Cable End With Manual Control Lever
Courtesy of FORD MOTOR CO.
With the adjuster locking tab unlocked, connect the selector lever cable end to the manual control lever.

Fig 6: Locating Selector Lever Cable End
Courtesy of FORD MOTOR CO.
Slide the adjuster tab to the LOCK position.

Fig 7: Sliding Adjuster Tab To LOCK Position
Courtesy of FORD MOTOR CO.
Install the Air Cleaner (ACL) and outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
Verify that the vehicle starts in PARK and NEUTRAL only and that the reverse lamps illuminate in REVERSE.