Common Specifications & Procedures
C- MAX COMMON SPECIFICATIONS & PROCEDURES
| System | Specifications/Procedures | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | Stage 1: 59 Ft. Lbs. (80 N.m) Stage 2: 90° |
||
| Rear | See INSTALLATION | ||
| Battery | SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||
| Front Disc Brakes w/Torque | SPECIFICATIONS | ||
| Rear Disc Brakes w/Torque | SPECIFICATIONS | ||
| Engine Cooling | |||
| General Service Specifications | SPECIFICATIONS | ||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | COOLANT PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION TEST - HYBRID | ||
| Oil Pressure (hot @ 2000 RPM.) | 29-60 psi | ||
| Overhaul | SPECIFICATIONS | ||
| Torque | SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | Stage 1: 50 Nm (37 lb-ft). Stage 2: 80 Nm (59 lb-ft). Stage 3: 112 Nm (83 lb-ft). |
||
| Fuel System | |||
| Fuel Filter Location | Located in fuel tank as part of Fuel Pump Module. | ||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Pressure Specification | SPECIFICATIONS | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE CHECK | ||
| Ignition | |||
| Ignition Wires (Routing) | Engines are equipped with Coil-on-plug ignition. | ||
| Spark Plugs | |||
| Type | AYFS 32Y R | ||
| Gap | .051 In. (1.3 mm) | ||
| Torque | 106 In. Lbs. (12 N.m) | ||
| Wheel Alignment | |||
| Adjustment Specifications | SPECIFICATIONS | ||
| Torque | SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (135 N.m) | ||