Disassembly and Assembly of Subassemblies: Differential: Disassembly
WARNING:
Before beginning any service procedure, refer to HEALTH AND SAFETY PRECAUTIONS
. Failure to follow this instruction may result in serious personal injury.
- Refer to: HEALTH AND SAFETY PRECAUTIONS .
-
NOTE: Install new bearings if necessary.
-
NOTE: Remove the bearing using a Bearing Puller and Step Plate.
Special Tool(s): 204-069 (T81P-1104-C) Remover/Installer, Front Wheel Hub
General Equipment: Puller
-
NOTE: Remove the bearing using a Bearing Puller and Step Plate.
Special Tool(s): 204-069 (T81P-1104-C) Remover/Installer, Front Wheel Hub
General Equipment: Puller
-
NOTE: If the ring gear is replaced, a new transfer shaft must also be installed.