Information System And Entertainment System (4.2 Inch Display) DTCS: FCDIM

FCDIM DTC CHART

DTC	Description	Action
U0155:00	Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information	GO to PINPOINT TEST AA .
U0184:00	Lost Communication With Radio: No Sub Type Information	GO to PINPOINT TEST AB .
U0253:00	Lost Communication With Accessory Protocol Interface Module: No Sub Type Information	GO to PINPOINT TEST AC .
U0256:00	Lost Communication With Front Controls Interface Module "A": No Sub Type Information	GO to PINPOINT TEST AD .
U201A:51	Control Module Main Calibration Data: Not Programmed	CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. If there have been recent service actions with this module, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. For more information, REFER to Programmable Module Installation (PMI) in MODULE CONFIGURATION SYSTEM . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM) .
U2100:00	Initial Configuration Not Complete: No Sub Type Information	CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. If there have been recent service actions with this module, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. For more information, REFER to Programmable Module Installation (PMI) in MODULE CONFIGURATION SYSTEM . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM) .
U2101:00	Control Module Configuration Incompatible: No Sub Type Information	CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. If there have been recent service actions with this module, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. For more information, REFER to Programmable Module Installation (PMI) in MODULE CONFIGURATION SYSTEM . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM) .
U3000:41	Control Module: General Checksum Failure	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCDIM. REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM) .
U3000:42	Control Module: General Memory Failure	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCDIM. REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM) .
U3003:16	Battery Voltage: Circuit Voltage Below Threshold	GO to PINPOINT TEST AF .
U3003:17	Battery Voltage: Circuit Voltage Above Threshold	GO to PINPOINT TEST AG .