LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2013 >> Fiesta Titanium, 4D Hatchback, Automatic DCT Trans >> Repair and Diagnosis >> Quick Lookups >> DTC Index >> Information System And Entertainment System DTCS >> Front Control/Display Interface Module (FCDIM)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Control/Display Interface Module (FCDIM)

FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) DTC CHART

DTC Description Action
B10BD:11 Multifunctional Switch: Circuit Short to Ground GO to PINPOINT TEST D .
B10BD:13 Multifunctional Switch: Circuit Open GO to PINPOINT TEST D .
B10BD:23 Multifunctional Switch: Signal Stuck Low GO to PINPOINT TEST D .
U0010:88 Medium Speed CAN Communication Bus: Bus Off REFER to MODULE COMMUNICATIONS NETWORK .
U0074:88 Control Module Communication Bus "B" Off: Bus Off REFER to MODULE COMMUNICATIONS NETWORK .
U1A00:00 Private Communication Network: No Sub Type Information GO to PINPOINT TEST Y .
U0140:00 Lost Communication With The BCM: No Sub Type Information GO to PINPOINT TEST P .
U0155:00 Lost Communication With The IPC Module: No Sub Type Information GO to PINPOINT TEST U .
U0193:00 Lost Communication With Digital Audio Control Module A: No Sub Type Information GO to PINPOINT TEST X .
U0423:68 Invalid Data Received From Instrument Panel Control Module: Event Information RETRIEVE and FOLLOW other DTCs present in the FCDIM or IPC.
U2100:00 Initial Configuration Not Complete: No Sub Type Information
  • This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM.
  • If there have been recent service actions with the FCDIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in MODULE CONFIGURATION SYSTEM .
  • If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM) .
U3000:00 Control Module: No Sub Type Information INSTALL a new FCDIM. REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM) . TEST the system for normal operation.
U3003:16 Battery Voltage: Circuit Voltage Below Threshold GO to PINPOINT TEST AE .
U3003:17 Battery Voltage: Circuit Voltage Above Threshold GO to PINPOINT TEST AF .