Body Control Module (BCM)
BODY CONTROL MODULE (BCM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1007:92 | High-Beam Headlamp Switch: Performance Or Incorrect Operation | REFER to EXTERIOR LIGHTING . |
| B1008:92 | Wiper Mode Switch: Performance Or Incorrect Operation | REFER to WIPERS AND WASHERS . |
| B1013:23 | Heater Rear Defog Switch: Signal Stuck Low | REFER to GLASS, FRAMES AND MECHANISMS . |
| B1034:12 | Left Front Seat Heater Element: Circuit Short To Battery | REFER to SEATING . |
| B1034:14 | Left Front Seat Heater Element: Circuit Short To Ground Or Open | REFER to SEATING . |
| B1051:92 | Front Washer Switch: Performance Or Incorrect Operation | REFER to WIPERS AND WASHERS . |
| B1052:92 | Rear Washer Switch: Performance Or Incorrect Operation | REFER to WIPERS AND WASHERS . |
| B108F:23 | Cabin Lock/Unlock Switch: Signal Stuck Low | REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS . |
| B1091:12 | Courtesy Lamp Sense: Circuit Short To Battery | REFER to INTERIOR LIGHTING . |
| B1092:12 | Daytime Running Light Relay: Circuit Short To Battery | REFER to EXTERIOR LIGHTING . |
| B1092:14 | Daytime Running Light Relay: Circuit Short To Ground Or Open | REFER to EXTERIOR LIGHTING . |
| B1098:11 | Left Position Light: Circuit Short To Ground | REFER to EXTERIOR LIGHTING . |
| B1098:15 | Left Position Light: Circuit Short To Battery Or Open | REFER to EXTERIOR LIGHTING . |
| B1099:11 | Right Position Light: Circuit Short To Ground | REFER to EXTERIOR LIGHTING . |
| B1099:15 | Right Position Light: Circuit Short To Battery Or Open | REFER to EXTERIOR LIGHTING . |
| B109A:12 | High Beam Relay: Circuit Short To Battery | REFER to EXTERIOR LIGHTING . |
| B109A:14 | High Beam Relay: Circuit Short To Ground Or Open | REFER to EXTERIOR LIGHTING . |
| B10A6:92 | Main Light Switch: Performance Or Incorrect Operation | REFER to EXTERIOR LIGHTING . |
| B10A8:12 | Low Beam Relay: Circuit Short To Battery | REFER to EXTERIOR LIGHTING . |
| B10A8:14 | Low Beam Relay: Circuit Short To Ground Or Open | REFER to EXTERIOR LIGHTING . |
| B10B1:92 | Cabin Set/Reset Switch: Performance Or Incorrect Operation | REFER to ANTI-THEFT - PERIMETER . |
| B10F1:23 | Key In Switch: Signal Stuck Low | REFER to INSTRUMENTATION, MESSAGE CENTER & WARNING CHIMES . |
| B1108:92 | Driver Door Central Locking Motor: Performance Or Incorrect Operation | REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS . |
| B1118:11 | Left Rear Sidemarker: Circuit Short To Ground | REFER to EXTERIOR LIGHTING . |
| B1118:15 | Left Rear Sidemarker: Circuit Short To Battery Or Open | REFER to EXTERIOR LIGHTING . |
| B113E:23 | External Boot/Trunk Release Switch: Signal Stuck Low | REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS . |
| B115A:23 | Front Passenger Seat Heater: Signal Stuck Low | REFER to SEATING . |
| B115B:23 | Front Driver Seat Heater: Signal Stuck Low | REFER to SEATING . |
| B1175:92 | Drivers Door Ajar Switch: Performance Or Incorrect Operation | REFER to INTERIOR LIGHTING . |
| B1176:92 | Passenger Door Ajar Switch: Performance Or Incorrect Operation | REFER to INTERIOR LIGHTING . |
| B1178:92 | Boot/Trunk Ajar Switch: Performance Or Incorrect Operation | REFER to INTERIOR LIGHTING . |
| B1187:92 | Trunk Motor: Performance Or Incorrect Operation | REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS . |
| B11DC:92 | Rear Wiper Mode Switch: Performance Or Incorrect Operation | REFER to WIPERS AND WASHERS . |
| B11E9:92 | Left Rear Door Ajar Switch: Performance Or Incorrect Operation | REFER to INTERIOR LIGHTING . |
| B11EA:92 | Right Rear Door Ajar Switch: Performance Or Incorrect Operation | REFER to INTERIOR LIGHTING . |
| B12F1:11 | Ambient Lighting Zone 1 Output: Circuit Short To Ground | REFER to INTERIOR LIGHTING . |
| B12F1:15 | Ambient Lighting Zone 1 Output: Circuit Short To Battery Or Open | REFER to INTERIOR LIGHTING . |
| B132B:12 | Left Stop/Turn Lamp: Circuit Short To Battery | REFER to EXTERIOR LIGHTING . |
| B132B:14 | Left Stop/Turn Lamp: Circuit Short To Ground Or Open | REFER to EXTERIOR LIGHTING . |
| B132C:12 | Right Stop/Turn Lamp: Circuit Short To Battery | REFER to EXTERIOR LIGHTING . |
| B132C:14 | Right Stop/Turn Lamp: Circuit Short To Ground Or Open | REFER to EXTERIOR LIGHTING . |
| B134E:23 | Switch Illumination Adjustment Control: Signal Stuck Low | REFER to INSTRUMENT CLUSTER AND PANEL ILLUMINATION . |
| B1A84:41 | Car Configuration Data: General Checksum Failure | CARRY OUT PMI on the BCM. REFER to MODULE CONFIGURATION . CLEAR the DTCs. REPEAT the self-test. If DTC B1A84:41 is retrieved again, INSTALL a new BCM. REFER to Body Control Module (BCM) . TEST the system for normal operation. |
| B1A84:51 | Car Configuration Data: Not Programmed | CARRY OUT PMI on the BCM. REFER to MODULE CONFIGURATION . CLEAR the DTCs. REPEAT the self-test. If DTC B1A84:51 is retrieved again, INSTALL a new BCM. REFER to Body Control Module (BCM) . TEST the system for normal operation. |
| B1C45:24 | Front Wiper Park Position Switch: Signal Stuck High | REFER to WIPERS AND WASHERS . |
| B1C53:13 | Front Wiper Intermittent Data: Circuit Open | REFER to WIPERS AND WASHERS . |
| B1D06:11 | Left Turn Indicator: Circuit Short To Ground | REFER to EXTERIOR LIGHTING . |
| B1D06:15 | Left Turn Indicator: Circuit Short To Battery Or Open | REFER to EXTERIOR LIGHTING . |
| B1D07:11 | Right Turn Indicator: Circuit Short To Ground | REFER to EXTERIOR LIGHTING . |
| B1D07:15 | Right Turn Indicator: Circuit Short To Battery Or Open | REFER to EXTERIOR LIGHTING . |
| B1D14:11 | Interior Lights Circuit "B": Circuit Short To Ground | REFER to INTERIOR LIGHTING . |
| B1D35:23 | Hazard Switch: Signal Stuck Low | REFER to EXTERIOR LIGHTING . |
| B1D36:92 | Turn Indicator Switch: Performance Or Incorrect Operation | REFER to EXTERIOR LIGHTING . |
| C1137:24 | Reverse Gear Switch: Signal Stuck High | REFER to EXTERIOR LIGHTING . |
| P062F:41 | Internal Control Module EEPROM Error: General Checksum Failure | CARRY OUT Programmable Module Installation (PMI) on the BCM. REFER to MODULE CONFIGURATION . |
| P062F:46 | Internal Control Module EEPROM Error: Calibration/Parameter Memory Failure | CARRY OUT the Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is NOT Available procedure. REFER to MODULE CONFIGURATION . TEST the system for normal operation. |
| P1397:00 | System Voltage Out Of Self Test Range: No Sub Type Information | GO to Pinpoint Test A . |
| P254F:00 | Engine Hood Switch Circuit/Open: No Sub Type Information | REFER to ANTI-THEFT - PERIMETER . |
| U0010:88 | Medium Speed CAN Communication Bus: Bus Off | REFER to MODULE COMMUNICATIONS NETWORK . |
| U0121:00 | Lost Communication With Anti-Lock Brake System (ABS) Control Module: No Sub Type Information | GO to Pinpoint Test B . |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test C . |
| U0167:00 | Lost Communication With Vehicle Immobilizer Control Module: No Sub Type Information | GO to Pinpoint Test D . |
| U0257:00 | Lost Communication With Front Controls/Display Interface Module: No Sub Type Information | GO to Pinpoint Test E . |
| U0415:68 | Invalid Data Received From Anti-Lock Brake System (ABS) Control Module: Event Information | RETRIEVE and REPAIR all non-network DTCs set in the ABS module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROL or the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) . |
| U2005:81 | Vehicle Speed: Invalid Serial Data Received | A speed signal is detected during the self-test. DIAGNOSE any symptoms or other module DTCs that are present. CLEAR the DTCs. REPEAT the BCM self-test. If no other symptoms (inaccurate speedometer) or DTCs are present, INSTALL a new BCM. REFER to Body Control Module (BCM) . TEST the system for normal operation. |
| U2010:11 | Switch Illumination: Circuit Short To Ground | REFER to INSTRUMENT CLUSTER AND PANEL ILLUMINATION . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | CARRY OUT Programmable Module Installation (PMI) on the BCM. REFER to MODULE CONFIGURATION . |
| U3000:44 | Control Module: Data Memory Failure | CARRY OUT PMI on the BCM. REFER to MODULE CONFIGURATION . CLEAR the DTCs. REPEAT the self-test. If DTC U3000:44 is retrieved again, INSTALL a new BCM. REFER to Body Control Module (BCM) . TEST the system for normal operation. |
| U3000:45 | Control Module: Program Memory Failure | CARRY OUT PMI on the BCM. REFER to MODULE CONFIGURATION . CLEAR the DTCs. REPEAT the self-test. If DTC U3000:45 is retrieved again, INSTALL a new BCM. REFER to Body Control Module (BCM) . TEST the system for normal operation. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test F . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test G . |