LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2013 >> Focus ST >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> 2013 6.7L Diesel >> Drive Cycle Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Drive Cycle Procedure

NOTE: Make sure an 8 hour cold soak time is allowed before beginning the drive cycle procedure.
NOTE: If a diesel particulate filter (DPF) regeneration event occurs before or during the drive cycle, multiple drive cycles may be required.
  1. Ignition ON. Do not crank until the WAIT TO START light cycles, or at least 10 seconds, whichever occurs first.
  2. Start the engine. Idle in PARK or NEUTRAL for 40 seconds.
  3. Before continuing, the engine oil temperature must exceed 70°C (158°F) and the exhaust gas temperature must exceed 160°C (320°F).
  4. The following outlines the appropriate conditions for running certain OBD monitors that require the engine to be under load: Accelerate steadily to third gear (M/T use fourth gear) and hold at 1,500 RPM for 3 seconds. Accelerate steadily from 56 km/h (35 mph) to 105 km/h (65 mph) over approximately 15 seconds (M/T 11 seconds minimum). Carry out a closed pedal decel fuel shut off event without applying the brake for 5 seconds. Repeat Step 4.a. and b. 3 times. Drive between 72.42 km/h (45 mph) and 104.6 km/h (65 mph) for 8.05 km (5 mi).
  5. Idle the vehicle for 2 minutes in PARK or NEUTRAL.
  6. Ignition OFF.
  7. Repeat the Quick Test.
scientia non olet · About LEMON Manuals