LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2013 >> Fusion Energi Titanium >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft System - Passive Anti-Theft System (Pats) With Push Button Start -- Hybrid >> General Procedures >> Key Programming Using Two Programmed Keys >> Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Key Programming Using Two Programmed Keys: Programming

NOTE: This procedure works only if the spare key programming is enabled.
NOTE: Two previously programmed keys are required to perform this procedure. All the steps must be completed within 30 seconds.
NOTE: Make sure all the doors are closed prior to beginning this procedure and that they remain closed until the procedure is complete.
  1. Locate the passive key backup starting location.

    Refer to: Passive Anti-Theft System (PATS) - Component Location .

  2. Place the first programmed passive key in the backup starting location.
  3. Wait 5 seconds and then press the START/STOP button.
  4. Remove the first programmed passive key.
  5. Within 10 seconds, place the second programmed passive key in the backup starting location and press the START/STOP button.
  6. Wait 5 seconds and press the START/STOP button.
  7. Remove the second programmed passive key.
  8. NOTE: A maximum of 4 keys can be programmed into the vehicle.

    Wait 5 seconds and then place the unprogrammed passive key in the backup starting location and press the START/STOP button.

  9. NOTE: If the key does not successfully program, wait at least 10 seconds before attempting to repeat the procedure.

    Verify the RKE  transmitter operates and the vehicle starts using the new passive key.

scientia non olet · About LEMON Manuals