Removal and Installation
- Disconnect the 4 ignition coil-on-plug electrical connectors.
- Remove the 4 bolts and the ignition coils.
- To install, tighten to 10 Nm (89 lb-in).
- Inspect the coil boots for rips, nicks or tears. Remove and discard any damaged coil boots.
- To install, slide the new coil boot onto the coil until it is fully seated at the top of the coil.
- To install, reverse the removal procedure.
- Apply a small amount of dielectric compound to the inside of the ignition coil boots prior to attaching to the spark plugs.
NOTE:
When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.