Powertrain Control Module (PCM): Installation
- Torque:
27 lb.in (3 Nm)
- Install the LH fender splash shield.
Refer to: FENDER SPLASH SHIELD .
-
NOTE: This step is only necessary when installing a new component.
Upload the module information from the diagnostic tool using the Programmable Modules Installation routine.
Refer to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION .
Use the General Equipment: Ford Diagnostic Equipment
-
- Reprogram the PATS . Carry out the Parameter Reset procedure. For vehicles without Intelligent Access (IA). Refer to: PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET .
- Reprogram the PATS . Carry out the Parameter Reset procedure. For vehicles with Intelligent Access (IA). Refer to: PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET .
- After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure.