Common Specifications & Procedures
EXPEDITION & NAVIGATOR COMMON SPECIFICATIONS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | GENERAL SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front Hub Nut | 30 Ft. Lbs. (40 Nm) | ||
| Rear Hub Nut | 221 Ft. Lbs. (300 Nm) | ||
| Battery | SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING . | ||
| Disc Brakes | |||
| Front | SPECIFICATIONS | ||
| Rear | SPECIFICATIONS . | ||
| Charging | |||
| Generator w/Torque | SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | ACCESSORY DRIVE | ||
| Belt Routing | ACCESSORY DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | SPECIFICATIONS | ||
| Radiator Cap Pressure | 16 psi (110 kPa) | ||
| Thermostat R & I | THERMOSTAT AND THERMOSTAT HOUSING . | ||
| Water Pump R & I | COOLANT PUMP . | ||
| Engine Mechanical | |||
| 5.4L (3V) | |||
| Compression | SPECIFICATIONS . | ||
| Minimum oil pressure at idle (engine at normal operating temperature, transmission in park) | 15 psi (103 kPa) | ||
| Overhaul | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | For sequence refer to FLEXPLATE 59 Ft. Lbs. (80 Nm) |
||
| Fuel System | |||
| Fuel Filter Location | The fuel tank(s) has a fuel filter that is part of the Fuel Pump (FP) module and cannot be serviced separately from the FP module | ||
| Fuel Filter R & I | FUEL PUMP MODULE | ||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Pressure Specification | SPECIFICATIONS | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST . | ||
| Ignition | |||
| Ignition Cable Resistance | Engine has coil-on-plug ignition. | ||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Spark Plugs | |||
| 5.4L (3V) | |||
| Type | Motorcraft HJFS-24FP | ||
| Gap | 0.039-0.043 In. (1.05 +/- 0.05 mm) | ||
| Torque | 106 Lbs.in (12 N.m) | ||
| Starting | |||
| Starter w/Torque | SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| With rear coil spring suspension | ALIGNMENT SPECIFICATIONS VEHICLES WITH REAR COIL SPRING SUSPENSION | ||
| With rear air suspension | ALIGNMENT SPECIFICATIONS VEHICLES WITH REAR AIR SUSPENSION | ||
| Torque | |||
| RWD vehicles | TORQUE SPECIFICATIONS | ||
| 4WD vehicles | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 150 Ft. Lbs. (204 N.m) | ||