Front Control Interface Module (FCIM)

DTC INDEX

DTC	Description	Action
U0140:00	Lost Communication With Body Control Module: No Sub Type Information	GO to PINPOINT TEST AC .
U0184:00	Lost Communication With Radio: No Sub Type Information	GO to PINPOINT TEST AI .
U2013:63	Switch Pack: Circuit/Component Protection Time-Out	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U2013:63 is retrieved again, INSTALL a new FCIM . REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) .
U2014:41	Control Module Hardware: General Checksum Failure	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U2014:41 is retrieved again, INSTALL a new FCIM . REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) .
U2014:42	Control Module Hardware: General Memory Failure	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U2014:42 is retrieved again, INSTALL a new FCIM . REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) .
U201A:51	Control Module Main Calibration Data: Not Programmed	CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. If there have been recent service actions with this module, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. For more information, REFER to Programmable Module Installation (PMI) in MODULE CONFIGURATION . If there have been no recent service actions, INSTALL a new FCIM to correct the failure to retain configuration data. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) .
U3003:16	Battery Voltage: Circuit Voltage Below Threshold	GO to PINPOINT TEST AN .
U3003:17	Battery Voltage: Circuit Voltage Above Threshold	GO to PINPOINT TEST AO .