DTC U2100: Initial Configuration Not Complete: Description

The PSCM is self monitoring and will carry out self-tests at specific intervals (initial power up, power down, during normal operation, etc.). Each self-test requires the voltage supply to the PSCM to be between 10 and 16 volts and the vehicle speed to be below 2 km/h (1.24 mph) for the test to take place. If one or more of the self-tests should fail, then the module will set one or more DTCs.

• DTC U2100:00 (Initial Configuration Not Complete: No Sub Type Information) - This DTC will set if the initial PSCM configuration was not carried out or if the configuration fails. The PSCM is configured from as-built data broadcast from the IPC over the HS-CAN. This DTC sets if the PSCM fails to receive the configuration data from the IPC.