Diagnostic Aids

DTC U3000:05, the PSCM disables steering assist and enters a manual mode. The PSCM will send a message to the IPC to display POWER STEERING MALFUNCTION SERVICE NOW in the message center.

DTC U3000:41, the PSCM disables steering assist and enters into a manual mode. The PSCM will send a message to the IPC to display POWER STEERING MALFUNCTION SERVICE NOW in the message center.

For DTC U3000:44, the PSCM will send a message to the IPC to display the POWER STEERING MALFUNCTION SERVICE NOW message in the message center.

For DTC U3000:46, initially the PSCM will use a default steering assist and may set DTC U2100:00. If DTC U3000:46 returns on the next ignition cycle, then the PSCM will disable steering assist, enter into a manual mode and send a message to the instrument cluster to display the POWER STEERING MALFUNCTION SERVICE NOW message in the message center.

DTC U3000:49, the PSCM disables steering assist and enters a manual mode. The PSCM will send a message to the IPC to display POWER STEERING MALFUNCTION SERVICE NOW in the message center.

For DTC U3000:61, the PSCM disables steering assist, the EPAS system enters manual steering mode and an invalid steering angle message is transmitted over the HS-CAN. The PSCM will send a message to the IPC to display POWER STEERING MALFUNCTION SERVICE NOW in the message center.

For DTC U3000:96, the instrument cluster will display the POWER STEERING MALFUNCTION SERVICE NOW in the message center when this DTC is set. DTC U3000:96 cannot be cleared using the scan tool, to clear this DTC follow the pinpoint test instructions.