Compressor Driver Module

NOTE: For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD .

Remove the rear floor console refrigerator. Refer to REFRIGERATOR .
NOTE: Do not bend the condenser tubes. The screwdriver must fit between the condenser tubes or damage may occur to the refrigerator.

Using a long thin screwdriver, remove the Phillips screw from the compressor driver module mounting bracket.

Fig 1: Removing Philips Screw From Compressor Driver Module Mounting Bracket
Courtesy of FORD MOTOR CO.
Disconnect the upper electrical connector from the compressor driver module.

Fig 2: Locating Compressor Driver Module Upper Electrical Connector
Courtesy of FORD MOTOR CO.
Rotate the compressor driver module to the right and remove from the mounting bracket.

Fig 3: Rotating Compressor Driver Module To Right
Courtesy of FORD MOTOR CO.
Disconnect the lower electrical connector from the compressor driver module.

Fig 4: Locating Compressor Driver Module Lower Electrical Connector
Courtesy of FORD MOTOR CO.
Disconnect the compressor driver module-to-refrigerator electrical connector.

Fig 5: Locating Compressor Driver Module-To-Refrigerator Electrical Connector
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.