LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2014 >> Flex SEL, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle External Controls >> Removal And Installation >> Selector Lever Cable >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Selector Lever Cable: Installation

    • Tighten to 7 Nm (62 lb-in).
      G07430639
  2. NOTE: Route the selector lever cable under the heater housing as noted during removal.
    G08616258
  3. G08616259
  4. NOTE: When installing the selector lever cable, make sure the selector lever cable locking tabs are locked in place. Press the selector lever cable into the selector lever housing and listen for the selector lever cable retainer to click in place. Pull back on the selector lever cable to make sure the selector lever is locked into the selector lever housing.
    G08616250
  5. G08616249
  6. NOTE: Failure to use a piece of cardboard between the LH  center console lower trim panel and the center console can result in damage to the side of the center console.
    G08616248
  7. G08616238
  8. G08616239
  9. Place the selector lever in DRIVE.
  10. G08616255
  11. NOTE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the selector lever cable bracket.
    NOTE: When installing the selector lever cable, make sure the selector lever cable locking tabs are locked in place. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable retainer to click in place. Pull back on the selector lever cable to make sure the selector lever is locked into the selector lever cable bracket.
    G07430632
    • 1. Rotate the manual control lever clockwise until it stops.
    • 2. Rotate the manual control lever counterclockwise one detent.
      G07430647
    • 1. Gently pry the latch up.
    • 2. Push the lock tab to slide it over.
      G07430648
  14. G07430649
  15. NOTE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the selector lever cable bracket.
    NOTE: Make sure the selector lever cable end is correctly installed onto the manual control lever ball stud by pulling back on the selector lever cable end.
    G07430650
  16. NOTE: After locking the adjuster, pull back on the adjuster to make sure it is securely installed.
    G07430651
  17. Install the ACL  and outlet pipe. Refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  18. Verify the vehicle starts in PARK and NEUTRAL only and the reverse lamps illuminate in REVERSE.
scientia non olet · About LEMON Manuals