Vehicles With Am/Fm/Cd/Sync/Touchscreen: FCIM

DTC INDEX

DTC	Description	Action
U0155:87	Lost Communication With Instrument Panel Cluster (IPC) Control Module: Missing Message	GO to PINPOINT TEST AG
U0257:87	Lost Communication With Front Controls/Display Interface Module: Missing Message	NOTE: Despite the description, this DTC applies to the FDIM, not the FCDIM GO to PINPOINT TEST AN
U2013:63	Switch Pack: Circuit/Component Protection Time-Out	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U2013:63 is retrieved again, INSTALL a new FCIM. REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U201A:51	Control Module Main Calibration Data: Not Programmed	This DTC sets due to an incomplete or incorrect FCIM PMI. CHECK the vehicle service history for recent service actions related to the FCIM. If there have been recent service actions with the FCIM, REPEAT/PERFORM the FCIM PMI procedure as directed by the diagnostic scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PMI . If there have been no recent service actions, the FCIM has failed to retain configuration data. INSTALL a new FCIM. REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U3000:41	Control Module: General Checksum Failure	This DTC sets due to an incomplete or incorrect FCIM PMI. CHECK the vehicle service history for recent service actions related to the FCIM. If there have been recent service actions with the FCIM, REPEAT/PERFORM the FCIM PMI procedure as directed by the diagnostic scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PMI . If there have been no recent service actions, the FCIM has failed to retain configuration data. INSTALL a new FCIM. REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U3000:42	Control Module: General Memory Failure	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCIM. REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U3003:16	Battery Voltage: Circuit Voltage Below Threshold	GO to PINPOINT TEST AO
U3003:17	Battery Voltage: Circuit Voltage Above Threshold	GO to PINPOINT TEST AP