Vehicles With Am/Fm/Cd/Sync: FCDIM

DTC INDEX

DTC	Description	Action
B11BA:1C	Steering Wheel Audio Switch Pack: Circuit Voltage Out of Range	GO to PINPOINT TEST U
B11BA:63	Steering Wheel Audio Switch Pack: Circuit/Component Protection Time-Out	GO to PINPOINT TEST U
C1001:01	Vision System Camera: General Electrical Failure	REFER to: PARKING AID . See THE REAR VIDEO IS INOPERATIVE .
U0155:00	Lost Communication With Instrument Panel Cluster IPC Control Module: No Sub Type Information	GO to PINPOINT TEST Z
U0184:00	Lost Communication With Radio: No Sub Type Information	GO to PINPOINT TEST AA
U0253:00	Lost Communication With Accessory Protocol Interface Module: No Sub Type Information	GO to PINPOINT TEST AB
U2013:87	Switch Pack: Missing Message	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U2013:87 is retrieved again, INSTALL a new FCIM. REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U201A:51	Control Module Main Calibration Data: Not Programmed	This DTC sets due to an incomplete or incorrect FCDIM PMI. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the FCDIM PMI procedure as directed by the diagnostic scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PMI . If there have been no recent service actions, the FCDIM has failed to retain configuration data. INSTALL a new FCDIM. REFER to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) .
U2100:00	Initial Configuration Not Complete: No Sub Type Information	This DTC sets due to an incomplete or incorrect FCDIM PMI. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the FCDIM PMI procedure as directed by the diagnostic scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PMI . If there have been no recent service actions, the FCDIM has failed to retain configuration data. INSTALL a new FCDIM. REFER to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) .
U2101:00	Control Module Configuration Incompatible: No Sub Type Information	This DTC sets due to an incomplete or incorrect FCDIM PMI. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the FCDIM PMI procedure as directed by the diagnostic scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PMI . If there have been no recent service actions, the FCDIM has failed to retain configuration data. INSTALL a new FCDIM. REFER to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) .
U3000:41	Control Module: General Checksum Failure	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCDIM. REFER to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) .
U3000:42	Control Module: General Memory Failure	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCDIM. REFER to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) .
U3003:16	Battery Voltage: Circuit Voltage Below Threshold	GO to PINPOINT TEST AD
U3003:17	Battery Voltage: Circuit Voltage Above Threshold	GO to PINPOINT TEST AE