Repair procedures: Removal
WARNING: This page is about a different car, the 2014 Hyundai Elantra GT and 2013 Hyundai Elantra GT. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
- Disconnect the negative (-) battery cable.
- Remove the air cleaner assembly and air duct.
(Refer to "AIR CLEANER ")
- Remove the air cleaner assembly.
(Refer to "AIR CLEANER ")
- Remove the shift cable mounting nut (B).
Tightening torque: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 Kgf.m, 5.7 ~ 8.6 lb-ft)
- Disconnect the inhibitor switch connector (A).
- Remove the manual control lever (B) and the washer after removing a nut (A).
CAUTION: When installing, affix the manual control lever and the inhibitor switch with Ø5mm (0.1969in.). Then tighten the inhibitor assembly mounting bolts.
- Remove the inhibitor assembly (A) after removing the bolts (2ea).
Tightening torque: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
CAUTION: When installing, tighten the inhibitor assembly mounting bolt lightly, so that necessary adjustments can be made. Tighten to specifications.