ACM - Premium
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1A01:01 | Speaker #1: General Electrical Failure | For a LF door speaker concern, GO to Pinpoint Test F . For a LF tweeter speaker concern, GO to Pinpoint Test G . |
| B1A01:11 | Speaker #1: Circuit Short To Ground | For a LF door speaker concern, GO to Pinpoint Test F . For a LF tweeter speaker concern, GO to Pinpoint Test G . |
| B1A01:12 | Speaker #1: Circuit Short To Battery | For a LF door speaker concern, GO to Pinpoint Test F . For a LF tweeter speaker concern, GO to Pinpoint Test G . |
| B1A01:13 | Speaker #1: Circuit Open | GO to Pinpoint Test F . |
| B1A02:01 | Speaker #2: General Electrical Failure | For a RF door speaker concern, GO to Pinpoint Test H . For a RF tweeter speaker concern, GO to Pinpoint Test I . |
| B1A02:11 | Speaker #2: Circuit Short To Ground | For a RF door speaker concern, GO to Pinpoint Test H . For a RF tweeter speaker concern, GO to Pinpoint Test I . |
| B1A02:12 | Speaker #2: Circuit Short To Battery | For a RF door speaker concern, GO to Pinpoint Test H . For a RF tweeter speaker concern, GO to Pinpoint Test I . |
| B1A02:13 | Speaker #2: Circuit Open | GO to Pinpoint Test H . |
| B1A03:01 | Speaker #3: General Electrical Failure | GO to Pinpoint Test J . |
| B1A03:11 | Speaker #3: Circuit Short To Ground | GO to Pinpoint Test J . |
| B1A03:12 | Speaker #3: Circuit Short To Battery | GO to Pinpoint Test J . |
| B1A03:13 | Speaker #3: Circuit Open | GO to Pinpoint Test J . |
| B1A04:01 | Speaker #4: General Electrical Failure | GO to Pinpoint Test K . |
| B1A04:11 | Speaker #4: Circuit Short To Ground | GO to Pinpoint Test K . |
| B1A04:12 | Speaker #4: Circuit Short To Battery | GO to Pinpoint Test K . |
| B1A04:13 | Speaker #4: Circuit Open | GO to Pinpoint Test K . |
| B1A56:21 | Antenna: Signal Amplitude < Minimum | GO to Pinpoint Test A . |
| B1A89:11 | Satellite Antenna: Circuit Short To Ground | GO to Pinpoint Test B . |
| B1A89:13 | Satellite Antenna: Circuit Open | GO to Pinpoint Test B . |
| B1D19:49 | Compact Disc Unit: Internal Electronic Failure | CLEAR the DTC. REPEAT the self-test. If DTC B1D19:49 is retrieved again, INSTALL a new ACM. Refer to Audio Control Module (ACM) . |
| U0155:00 | Lost Communication With IPC Control Module: No Subject Type Information | GO to Pinpoint Test Y . |
| U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | GO to Pinpoint Test AA . |
| U0256:00 | Lost Communication With Front Controls Interface Module "A": No Sub Type Information | GO to Pinpoint Test AB . |
| U0257:00 | Lost Communication With Front Controls/ Display Interface Module: No Sub Type Information | GO to Pinpoint Test AC . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the ACM. If there have been recent service actions with the ACM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in REFER to Module Configuration . If there have been no recent service actions, INSTALL a new ACM to correct the failure to retain configuration data. REFER to Audio Control Module (ACM) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the ACM. If there have been recent service actions with the ACM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in REFER to Module Configuration . If there have been no recent service actions, INSTALL a new ACM to correct the failure to retain configuration data. REFER to Audio Control Module (ACM) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the ACM. If there have been recent service actions with the ACM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in REFER to Module Configuration . If there have been no recent service actions, INSTALL a new ACM to correct the failure to retain configuration data. REFER to Audio Control Module (ACM) . |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTC. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new ACM. Refer to Audio Control Module (ACM) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the DTC. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new ACM. Refer to Audio Control Module (ACM) . |
| U3000:96 | Control Module: Component Internal Failure | GO to Pinpoint Test B . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AD . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AE . |