FCDIM - Premium
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| U0155:00 | Lost Communication With IPC Module: No Sub Type Information | GO to Pinpoint Test Y . |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | GO to Pinpoint Test Z . |
| U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | GO to Pinpoint Test AA . |
| U0256:00 | Lost Communication With Front Controls Interface Module: No Sub Type Information | GO to Pinpoint Test AB . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in Module Configuration . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to Front Controls/Display Interface Module (FCDIM) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in Module Configuration . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to Front Controls/Display Interface Module (FCDIM) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in Module Configuration . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to Front Controls/Display Interface Module (FCDIM) . |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:41 is still present, INSTALL a new FCDIM. Refer to Front Controls/Display Interface Module (FCDIM) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:42 is still present, INSTALL a new FCDIM. Refer to Front Controls/Display Interface Module (FCDIM) . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AD . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AE . |