FCIM - Premium
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B00D5:01 | Restraint System Passenger Disable Indicator: General Electrical Failure | CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B00D5:01 is still present, INSTALL a new FCIM. Refer to Front Controls Interface Module (FCIM) . |
| B113C:11 | Hazard Switch Illumination: Circuit Short To Ground | CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B113C:11 is still present, INSTALL a new FCIM. Refer to Front Controls Interface Module (FCIM) . |
| B1202:01 | Restraint System Passenger Enable Indicator: General Electrical Failure | CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B1202:01 is still present, INSTALL a new FCIM. Refer to Front Controls Interface Module (FCIM) . |
| U0155:00 | Lost Communication With IPC Module: No Sub Type Information | GO to Pinpoint Test Y . |
| U0257:00 | Lost Communication With Front Controls / Display Interface Module: No Sub Type Information | GO to Pinpoint Test AC . |
| U0423:00 | Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information | REFER to Instrumentation, Message Center, and Warning Chimes to RETRIEVE and FOLLOW DTCs present in the IPC. |
| U2013:63 | Switch Pack: Circuit / Component Protection Time-Out | GO to Pinpoint Test U . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCIM. If there have been recent service actions with the FCIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in Module Configuration . If there have been no recent service actions, INSTALL a new FCIM to correct the failure to retain configuration data. REFER to Front Controls Interface Module (FCIM) . |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:41 is still present, INSTALL a new FCIM. Refer to Front Controls Interface Module (FCIM) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:42 is still present, INSTALL a new FCIM. Refer to Front Controls Interface Module (FCIM) . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AD . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AE . |