Heated Steering Wheel Module (HSWM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B135C:11 | Heater Element: Circuit Short to Ground | GO to Pinpoint Test D . |
| B135C:15 | Heater Element: Circuit Short to Battery or Open | GO to Pinpoint Test D . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test F . |
| U0164:00 | Lost Communication With HVAC Control Module: No Sub Type Information | GO to Pinpoint Test F . |
| U0256:00 | Lost Communication With Front Controls Interface Module "A": No Sub Type Information | GO to Pinpoint Test F . |
| U0401:82 | Invalid Data Received From ECM/PCM A: Alive/Sequence Counter Incorrect/Not Updates | This DTC can set due to a fault in the PCM. CARRY OUT a self-test of the PCM and DIAGNOSE any PCM DTCs present. REFER to Electronic Engine Controls . |
| U0452:82 | Invalid Data Received From Restraints Control Module: Alive/Sequence Counter Incorrect/Not Updates | This DTC can set due to a fault in the Restraints Control Module. CARRY OUT a self-test of the Restraints Control Module and DIAGNOSE any Restraints Control Module DTCs present. REFER to Supplemental Restraint System . |
| U1000:00 | Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information | The Heated Steering Wheel Module (HSWM) has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The Heated Steering Wheel Module (HSWM) cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs and REPEAT the self-test. |
| U2100:55 | Initial Configuration Not Complete: Not Configured | CARRY OUT PMI on the Heated Steering Wheel Module (HSWM). REFER to Module Configuration , PMI. REPEAT the self-test. If PMI is successful, the DTC will not be present. If the DTC returns, INSTALL a new Heated Steering Wheel Module (HSWM). Refer to Heated Steering Wheel Module (HSWM) . TEST the system for normal operation. |
| U210A:11 | Temperature Sensor: Circuit Short to Ground | GO to Pinpoint Test E . |
| U210A:15 | Temperature Sensor: Circuit Short to Battery or Open | GO to Pinpoint Test E . |
| U3000:49 | Control Module: Internal Electronic Failure | INSTALL a new Heated Steering Wheel Module (HSWM). Refer to Heated Steering Wheel Module (HSWM) . TEST the system for normal operation. |