Steering Column Switches DTCS: SCCM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1007:09 | High-Beam Headlamp Switch: Component Failure | INSTALL a new multifunction switch. Refer to Steering Column Multifunction Switch . TEST the system for normal operation. If the concern still exists, INSTALL a new SCCM. Refer to Steering Column Control Module (SCCM) . |
| B1008:09 | Wiper Mode Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to Wipers and Washers . |
| B1051:09 | Front Washer Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to Wipers and Washers . |
| B1052:09 | Rear Washer Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to Wipers and Washers . |
| B10A6:09 | Main Light Switch: Component Failure | INSTALL a new FLM. REFER to Exterior Lighting . |
| B10AD:02 | Rain Sensor: General Signal Failure | If the rain sensitive wipers do not operate, Refer to article 'Wipers and Washers', Go to Pinpoint Test G . If the rain sensitive wipers operate correctly, DISREGARD this DTC. |
| B10AD:08 | Rain Sensor: Bus Signal/Message Failure | If the windshield wipers only operate when high speed mode is selected, Refer to article 'Wipers and Washers', Go to Pinpoint Test F . If the rain sensitive wipers do not operate, Refer to article 'Wipers and Washers', Go to Pinpoint Test G . |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | INSTALL a new rain sensor. REFER to Wipers and Washers . |
| B10AD:55 | Rain Sensor: Not Configured | This DTC sets due to incomplete or incorrect module programming, or due to an internal failure of the module. If the module has just recently been reprogrammed, attempt to PROGRAM the module again. RETRIEVE SCCM DTCs. If the DTC returns, INSTALL a new SCCM. Refer to Steering Column Control Module (SCCM) . |
| B1124:09 | Lamp Fade Control: Component Failure | INSTALL a new FLM. REFER to Exterior Lighting . |
| B1131:02 | Wiper Motor Module: General Signal Failure | If the windshield wipers are inoperative in all modes, Refer to article 'Wipers and Washers', Go to Pinpoint Test A . If the windshield wipers only operate when high speed mode is selected, Refer to article 'Wipers and Washers', Go to Pinpoint Test F . If the windshield wipers operate correctly, disregard this DTC. |
| B1131:08 | Wiper Motor Module: Bus Signal / Message Failure | If the windshield wipers are inoperative in all modes, Refer to article 'Wipers and Washers', Go to Pinpoint Test A . If the windshield wipers only operate when high speed mode is selected, Refer to article 'Wipers and Washers', Go to Pinpoint Test F . If the windshield wipers operate correctly, disregard this DTC. |
| B11D9:16 | Vehicle Battery: Circuit Below Threshold | GO to Pinpoint Test M . |
| B11D9:17 | Vehicle Battery: Circuit Above Threshold | GO to Pinpoint Test N . |
| B1298:09 | Steering Column Adjust Up Switch: Component Failure | INSTALL a new steering column control switch. Refer to Steering Column Control Switch . CLEAR the DTCs. VERIFY correct system operation and REPEAT the self-test.. If the DTC returns, INSTALL a new SCCM. Refer to Steering Column Control Module (SCCM) . |
| B1299:09 | Steering Column Adjust Down Switch: Component Failure | INSTALL a new steering column control switch. Refer to Steering Column Control Switch . CLEAR the DTCs. VERIFY correct system operation and REPEAT the self-test. If the DTC returns, INSTALL a new SCCM. Refer to Steering Column Control Module (SCCM) . |
| B12A1:09 | Steering Column Adjust Out Switch: Component Failure | INSTALL a new steering column control switch. Refer to Steering Column Control Switch . CLEAR the DTCs. VERIFY correct system operation and REPEAT the self-test. If the DTC returns, INSTALL a new SCCM. Refer to Steering Column Control Module (SCCM) . |
| B12A2:09 | Steering Column Adjust In Switch: Component Failure | INSTALL a new steering column control switch. Refer to Steering Column Control Switch . CLEAR the DTCs. VERIFY correct system operation and REPEAT the self-test. If the DTC returns, INSTALL a new SCCM. Refer to Steering Column Control Module (SCCM) . |
| B12F7:09 | Single Wipe Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to Wipers and Washers . |
| B1368:11 | Adjustable Pedal Position Feedback Sensor: Circuit Short To Ground | Refer to article 'Adjustable Pedals', Go to Pinpoint Test C . |
| B1368:12 | Adjustable Pedal Position Feedback Sensor: Circuit Short To Battery | Refer to article 'Adjustable Pedals', Go to Pinpoint Test C |
| B1369:09 | Pedal Adjustment Switch: Component Failure | INSTALL a new pedal adjust switch. TEST the system for normal operation. If the concern still exists, INSTALL a new SCCM. Refer to Steering Column Control Module (SCCM) . |
| B1375:18 | Steering Column Tilt Motor: Circuit Current Below Threshold | Refer to article 'Steering Column', Go to Pinpoint Test A . |
| B1375:19 | Steering Column Tilt Motor: Circuit Current Above Threshold | Refer to article 'Steering Column', Go to Pinpoint Test A . |
| B1375:71 | Steering Column Tilt Motor: Actuator Stuck | Refer to article 'Steering Column', Go to Pinpoint Test A . |
| B137D:18 | Pedal Adjustment Motor: Circuit Current Below Threshold | Refer to article 'Adjustable Pedals', Go to Pinpoint Test D . |
| B137D:19 | Pedal Adjustment Motor: Circuit Current Above Threshold | Refer to article 'Adjustable Pedals', Go to Pinpoint Test D . |
| B137D:71 | Pedal Adjustment Motor: Actuator Stuck | Refer to article 'Adjustable Pedals', Go to Pinpoint Test D . |
| B137E:18 | Steering Column Telescope Motor: Circuit Current Below Threshold | Refer to article 'Steering Column', Go to Pinpoint Test A . |
| B137E:19 | Steering Column Telescope Motor: Circuit Current Above Threshold | Refer to article 'Steering Column', Go to Pinpoint Test A . |
| B137E:71 | Steering Column Telescope Motor: Actuator Stuck | Refer to article 'Steering Column', Go to Pinpoint Test A . |
| B137F:09 | Steering Wheel Left Switch Pack: Component Failure | For message center concerns, Refer to article 'Instrumentation, Message Center, and Warning Chimes', Go to Pinpoint Test AD . For cruise control concerns, Refer to article 'Cruise Control Adaptive', Go to Pinpoint Test C . |
| B137F:11 | Steering Wheel Left Switch Pack: Circuit Short to Ground | For message center concerns, Refer to article 'Instrumentation, Message Center, and Warning Chimes', Go to Pinpoint Test AD . For cruise control concerns, Refer to article 'Cruise Control Adaptive', Go to Pinpoint Test C . |
| B137F:17 | Steering Wheel Left Switch Pack: Circuit Voltage Above Threshold | For message center concerns, Refer to article 'Instrumentation, Message Center, and Warning Chimes', Go to Pinpoint Test AD . For cruise control concerns, Refer to article 'Cruise Control Adaptive', Go to Pinpoint Test C . |
| B1380:09 | Steering Wheel Right Switch Pack: Component Failure | For premium audio system, Refer to article 'Information and Entertainment Systems Premium', Go to Pinpoint Test T . For premium plus audio system, Refer to article 'Information and Entertainment Systems Premium Plus', Go to Pinpoint Test V . For Sony ® sound audio system, Refer to article 'Information and Entertainment Systems Sony Sound', Go to Pinpoint Test W . |
| B1380:11 | Steering Wheel Right Switch Pack: Circuit Short to Ground | For premium audio system, Refer to article 'Information and Entertainment Systems Premium', Go to Pinpoint Test T . For premium plus audio system, Refer to article 'Information and Entertainment Systems Premium Plus', Go to Pinpoint Test V . For Sony ® sound audio system, Refer to article 'Information and Entertainment Systems Sony Sound', Go to Pinpoint Test W . |
| B1380:17 | Steering Wheel Right Switch Pack: Circuit Voltage Above Threshold | For premium audio system, Refer to article 'Information and Entertainment Systems Premium', Go to Pinpoint Test T . For premium plus audio system, Refer to article 'Information and Entertainment Systems Premium Plus', Go to Pinpoint Test V . For Sony ® sound audio system, Refer to article 'Information and Entertainment Systems Sony Sound', Go to Pinpoint Test W . |
| B13A6:09 | Lane Departure Warning (LDW) Switch Input: Component Failure | Refer to article 'Lane Departure Warning', Go to Pinpoint Test A . |
| B1C33:11 | Steering Column Tilt Feedback Signal: Circuit Short to Ground | Refer to article 'Steering Column', Go to Pinpoint Test C . |
| B1C33:12 | Steering Column Tilt Feedback Signal: Circuit Short to Battery | Refer to article 'Steering Column', Go to Pinpoint Test C . |
| B1C35:11 | Steering Column Telescope Feedback Signal: Circuit Short to Ground | Refer to article 'Steering Column', Go to Pinpoint Test C . |
| B1C35:12 | Steering Column Telescope Feedback Signal: Circuit Short to Battery | Refer to article 'Steering Column', Go to Pinpoint Test C . |
| B1D36:09 | Turn Indicator Switch: Component Failure | INSTALL a new multifunction switch. Refer to Steering Column Multifunction Switch . TEST the system for normal operation. If the concern still exists, INSTALL a new SCCM. Refer to Steering Column Control Module (SCCM) . |
| C0051:09 | Steering Wheel Position Sensor: Component Failure | INSTALL a new steering wheel rotation sensor. REFER to Anti-Lock Brake System (ABS) and Stability Control . |
| C0051:16 | Steering Wheel Position Sensor: Circuit Voltage Below Threshold | GO to Pinpoint Test L . |
| C0051:17 | Steering Wheel Position Sensor: Circuit Voltage Above Threshold | GO to Pinpoint Test L . |
| U1000:00 | Solid State Driver Protection Active-Driver Disabled: No Sub Type Information | This DTC is set when the DTC activates one or more of the FET circuit protectors. This DTC does not clear until the concern that activated the FET has been repaired and the SCCM passes a self-test. REPAIR all other SCCM DTCs then CARRY OUT a SCCM on-demand self-test. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to incomplete or incorrect module programming, or due to an internal failure of the module. If the module has just recently been reprogrammed, attempt to PROGRAM the module again. RETRIEVE SCCM DTCs. If the DTC returns, INSTALL a new SCCM. Refer to Steering Column Control Module (SCCM) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets if the steering wheel switches do not match the switch function configuration data in the SCCM. CHECK the part numbers in Ford Catalog Advantage™ or equivalent and CONFIRM the correct SCCM and steering wheel control switches are installed on the vehicle. |
| U3000:49 | Control Module: Internal Electronic Failure | INSTALL a new SCCM. Refer to Steering Column Control Module (SCCM) . |