April 5, 2026: LEMON Manuals is launched! Read the announcement.

Lumbar Assembly Power: Installation

1.

If equipped, position the TED duct between the power lumbar and cable.

GFD85808

Courtesy of FORD MOTOR COMPANY

2.

Engage the power lumbar retaining clips to the backrest frame and connect the motor.

3.

If equipped, connect the backrest TED electrical connector and engage the pin-type retainer.

4.

Roll the backrest cover down and attach the hook-and-loop strips.

5.

Route the wire harness(es) through the hole(s) in the backrest cover and engage the lower J-clips.

6.

On each side, wrap the backrest cover around the recliner and attach the hook-and-loop strips and clip.

GFD85792

Courtesy of FORD MOTOR COMPANY

7.

Install the seat backrest. For additional information, refer to Seat Backrest - Front in this article.