Possible Causes
- Calibration routine not complete
- ABS module
- AK1: CARRY OUT THE ABS MODULE/HCU CALIBRATION
- Ignition ON, engine OFF.
- Using a diagnostic scan tool, carry out the Inlet Valve Calibration and then the Master Cylinder Isolation Calibration.
- Clear the ABS DTCs.
- Ignition OFF.
- Ignition ON, engine OFF.
- Carry out the ABS self-test.
- Is DTC B10DF:46 still present?
Yes No Go to AK2. The systems is operating correctly. The concern was caused by an incomplete calibration. - AK2: CHECK FOR CORRECT ABS MODULE OPERATION
- Ignition OFF.
- Ignition ON, engine OFF.
- Using a diagnostic scan tool, carry out the Inlet Valve Calibration and then the Master Cylinder Isolation Calibration.
- Carry out the ABS self-test.
- Is DTC B10DF:46 still present?
Yes No INSTALL a new ABS module. CHECK OASIS for any applicable Technical Service Bulletins TSBs.
If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions.
If no TSBs address this concern, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROL .
ORDER a replacement ABS module and INCLUDE the RVC on the form.
If this is a Ford paid repair, INCLUDE the RVC on the warranty claim form.
When complete, SELECT the "X" in the top right corner to CLOSE this procedure.The systems is operating correctly. The concern was caused by an incomplete calibration. If this is a Ford paid repair, INCLUDE the RVC on the warranty claim form.
When complete, SELECT the "X" in the top right corner to CLOSE this procedure.