Possible Causes

E1: VERIFY THAT THE KEY IN USE IS NOT RESTRICTED

Does the message center display MYKEY ACTIVE DRIVE SAFELY?

Yes	No
The current key is a restricted key and is operating correctly. REPEAT the test using a different key until the message center does not display MYKEY ACTIVE DRIVE SAFELY. Go to E2.	Go to E2.

E2: VERIFY THE MYKEY® TRACTION CONTROL SETTING

Using the message center, verify the MyKey® traction control setting. Refer to the Owner's Literature for instructions on setting the MyKey® functions.

Is the MyKey® traction control setting configured to always on?

Yes	No
Go to E3.	Go to E4.

E3: VERIFY TRACTION CONTROL FUNCTION CAN BE DISABLED USING THE ADMIN KEY

Using the message center, verify traction control can be enabled and disabled using the admin key. Refer to the Owner's Literature for instructions on enabling and disabling traction control.

Can traction control be enabled and disabled using the admin key?

Yes	No
The system is operating correctly at this time. The concern may have been caused by the use of a restricted key. INFORM the customer the traction control can only be disabled using an admin key when the MyKey® traction control setting is configured to always on.	Go to E4.

E4: CHECK FOR ABS MODULE DTCS

Are any DTCs present?

Yes	No
REFER to the ABS Module DTC Chart .	Go to E6.

E5: CHECK FOR GWM DTCS

Are any DTCs present?

Yes	No
DIAGNOSE the GWM DTC. REFER to MODULE COMMUNICATIONS NETWORK .	Go to E6.

E6: CHECK FOR IPC DTCS

Are any DTCs present?

Yes	No
REFER to INFORMATION CENTER - INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES to diagnose the IPC DTC.	Go to E7.

E7: CHECK FOR BCM DTCS

Are any DTCs present?

Yes	No
REFER to MULTIFUNCTION ELECTRONIC MODULES to diagnose the BCM DTC.	The system is operating correctly at this time. The concern may have been caused due to high network traffic or an intermittent fault condition.