Vehicles With Am/Fm/Cd: FCDIM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| U0155:00 | Lost Communication With Instrument Panel Cluster IPC Control Module: No Sub Type Information | GO to Pinpoint Test T |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | GO to Pinpoint Test U |
| U2013:87 | Switch Pack: Missing Message | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U2013:87 is retrieved again, INSTALL a new FCIM. REFER to: Front Controls Interface Module (FCIM) |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to an incomplete or incorrect FCDIM PMI. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the FCDIM PMI procedure as directed by the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation). See PMI. If there have been no recent service actions, the FCDIM has failed to retain configuration data. INSTALL a new FCDIM. REFER to: Front Control/Display Interface Module (FCDIM) |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to an incomplete or incorrect FCDIM PMI. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the FCDIM PMI procedure as directed by the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation). See PMI. If there have been no recent service actions, the FCDIM has failed to retain configuration data. INSTALL a new FCDIM. REFER to: Front Control/Display Interface Module (FCDIM) |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation). See PMI. If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to: Front Control/Display Interface Module (FCDIM) |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) |
| U3000:42 | Control Module: General Memory Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test W |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test X |