LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2016 >> Edge SE, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System Component Testing >> DTC Symptom Index >> DTC Index >> SASM - Steering Angle Sensor Module >> DTC C1B00: Steering Angle Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC C1B00: Steering Angle Sensor

Failure Action
1C This DTC sets if the voltage supplied to the internal SASM sensors is less than 0.48 volt or greater than 6.5 volts. CARRY OUT the SASM Module Reset routine. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate REMOVAL AND INSTALLATION .
49 This DTC sets due to a failure the internal SASM sensors. CARRY OUT the SASM Module Reset routine. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate REMOVAL AND INSTALLATION .
54 This DTC sets if steering angle sensor trim routine has not been successfully carried out. CARRY OUT the Steering Wheel Angle Trim routine.
56 This DTC sets if the absolute steering wheel angle trim offset is greater than 15 degrees. CARRY OUT the Steering Wheel Angle Trim routine. CARRY OUT the IVD Initialization routine.
62 The SASM monitors the input and output of the internal sensors and compares the sensors to one another. This DTC sets the internal SASM sensors do not agree with each other. CARRY OUT the SASM Module Reset routine. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate REMOVAL AND INSTALLATION .
64 The SASM monitors the input and output of the internal sensors and compares this information to other inputs to determine sensor validity. This DTC sets if the internal SASM sensors do not agree with other inputs. CARRY OUT the SASM Module Reset routine. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate REMOVAL AND INSTALLATION .
81 This DTC sets if the SASM receives invalid serial data from outside sources. CARRY OUT the SASM Module Reset routine. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate REMOVAL AND INSTALLATION .
85 This DTC sets if the SASM steering angle sensor information is outside regular measuring range, -1, 080 degrees to +1, 080 degrees. CARRY OUT the SASM Module Reset routine. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals