Information System And Entertainment System (Am/Fm/Cd) DTCS: FCDIM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B10BD:11 | Multifunctional Switch: Circuit Short to Ground | GO to Pinpoint Test L |
| B10BD:13 | Multifunctional Switch: Circuit Open | GO to Pinpoint Test L |
| B10BD:23 | Multifunctional Switch: Signal Stuck Low | GO to Pinpoint Test L |
| U0001:88 | High Speed CAN Communication Bus: Bus Off |
NOTE:
The module was unable to communicate on the network at a point in time. The fault is not currently present since the module had to communicate with the diagnostic scan tool to report this DTC. To avoid repeat network concerns: INSPECT for damaged or corroded wiring at the FCDIM. Refer to Wiring Diagrams Module Communications Network
for schematic and connector information.CLEAR the DTC.WAIT at least 10 seconds.REPEAT the network test with the diagnostic scan tool. |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test O |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test P |
| U0193:00 | Lost Communication With "Digital Audio Control Module A:" No Sub Type Information | GO to Pinpoint Test Q |
| U0423:68 | Invalid Data Received From Instrument Panel Cluster Control Module: Event Information | RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC. REFER to: Instrumentation, Message Center and Warning Chimes |
| U1A00:00 | Private Communication Network: No Sub Type Information | GO to Pinpoint Test M |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description See PMI. If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to: Front Control/Display Interface Module (FCDIM) |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM. If there have been recent service actions with the FCDIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description See PMI. If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to: Front Control/Display Interface Module (FCDIM) |
| U3000:00 | Control Module: No Sub Type Information | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:00 is retrieved again, INSTALL a new FCDIM. REFER to: Front Control/Display Interface Module (FCDIM) |
| U3006:16 | Control Module Input Power "A:" Circuit Voltage Below Threshold | GO to Pinpoint Test U |
| U3006:17 | Control Module Input Power "A:" Circuit Voltage Above Threshold | GO to Pinpoint Test V |