Information System And Entertainment System (Am/Fm/Cd/Sync/Touchscreen Display) DTCS: FCIM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B13DC:11 | Compact Disc Slot Illumination: Circuit Short To Ground | REFER to: Instrument Panel and Interior Switches Illumination |
| B13DC:12 | Compact Disc Slot Illumination: Circuit Short To Battery | REFER to: Instrument Panel and Interior Switches Illumination |
| B13DC:13 | Compact Disc Slot Illumination: Circuit Open | REFER to: Instrument Panel and Interior Switches Illumination |
| U0155:87 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: Missing Message | GO to Pinpoint Test AH |
| U0257:87 | Lost Communication With Front Controls / Display Interface Module: Missing Message | GO to Pinpoint Test AN |
| U0423:00 | Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information | RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC. Refer to: Instrumentation, Message Center and Warning Chimes If no Diagnostic Trouble Codes (DTCs) are present in the IPC, DIAGNOSE the observable symptom. |
| U2013:63 | Switch Pack: Circuit/Component Protection Time-Out | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U2013:63 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM) |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to incomplete or incorrect PMI procedures. CHECK vehicle service history for recent service actions related to the FCIM. If there have been recent service actions with this module, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. Refer to: Module Configuration - System Operation and Component Description If there have been no recent service actions, INSTALL a new FCIM to correct the failure to retain configuration data. Refer to: Front Controls Interface Module (FCIM) |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM) |
| U3000:42 | Control Module: General Memory Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM) |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AO |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AP |