LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2016 >> Escape S >> Repair and Diagnosis >> Quick Lookups >> DTC Index >> DTC Index (Exterior Lighting System - Module Communications Network) >> Information System And Entertainment System (SONY Audio System) DTCS >> FCIM
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Information System And Entertainment System (SONY Audio System) DTCS: FCIM

DTC INDEX

DTC Description Action
B13DC:11 Compact Disc Slot Illumination: Circuit Short To Ground REFER to: Instrument Panel and Interior Switches Illumination
B13DC:12 Compact Disc Slot Illumination: Circuit Short To Battery REFER to: Instrument Panel and Interior Switches Illumination
B13DC:13 Compact Disc Slot Illumination: Circuit Open REFER to: Instrument Panel and Interior Switches Illumination
U0009:88 High Speed CAN Communication Bus (-) shorted to Bus (+): Bus off An I-CAN fault was detected by the FCIM in the past. The fault is not currently present, as the module must communicate with the diagnostic scan tool to report this DTC. To diagnose communication network concerns, REFER to: Communications Network
U0155:00 Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information GO to Pinpoint Test AF
U0257:00 Lost Communication With Front Control/Display Interface Module: No Sub Type Information GO to Pinpoint Test AL
U0423:00 Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC. Refer to: Instrumentation, Message Center and Warning Chimes
If no Diagnostic Trouble Codes (DTCs) are present in the IPC, DIAGNOSE the observable symptom.
U2013:63 Switch Pack: Circuit/Component Protection Time-Out CLEAR the Diagnostic Trouble Codes (DTCs).
WAIT at least 10 seconds.
REPEAT the self-test.
If DTC U2013:63 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM)
U3000:41 Control Module: General Checksum Failure CLEAR the Diagnostic Trouble Codes (DTCs).
WAIT at least 10 seconds.
REPEAT the self-test.
If DTC U3000:41 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM)
U3000:42 Control Module: General Memory Failure CLEAR the Diagnostic Trouble Codes (DTCs).
WAIT at least 10 seconds.
REPEAT the self-test.
If DTC U3000:42 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM)
U3003:16 Battery Voltage: Circuit Voltage Below Threshold GO to Pinpoint Test AM
U3003:17 Battery Voltage: Circuit Voltage Above Threshold GO to Pinpoint Test AN