Selector Lever Knob: Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The SelectShift™ switch is part of the selector lever knob. To install a new SelectShift™ switch a new selector lever knob must be installed.
- 1.
Fully apply the parking brake.
 Courtesy of FORD MOTOR COMPANY
|
- 2.
Lift the selector lever bezel up and disconnect the electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 3.
Disconnect the selectshift switch electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
Remove the retainers and the selector lever knob.
 Courtesy of FORD MOTOR COMPANY
|
- 5.
Release the tabs and remove the selector lever bezel from the selector lever.
 Courtesy of FORD MOTOR COMPANY
|