Side And Rear Vision System DTCS
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | GO to Pinpoint Test D . |
| B11D6:15 | Driver Display Alert LED: Circuit Short To Battery Or Open | If the suspect BLIS ® /CTA LED is inoperative, GO to Pinpoint Test D
. If the suspect /CTA LED is always on, GO to Pinpoint Test I . |
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test J . |
| U0101:00 | Lost Communication With TCM: No Sub Type Information | GO to Pinpoint Test K . |
| U0146:00 | Lost Communication With Gateway "A": No Sub Type Information | GO to Pinpoint Test L . |
| U0401:86 | Invalid Data Received From ECM/PCM "A": Signal Invalid | This DTC sets when the SOD-L or SOD-R receives invalid network data from the PCM with a faulted signal data input. RETRIEVE and REPAIR all non-network DTCs in the PCM. If no DTCs are present in the PCM, DIAGNOSE the observable symptom. |
| U0402:86 | Invlaid Data Received From TCM: Signal Invalid | This DTC sets when the SOD-L or SOD-R receives invalid network data from the PCM with a faulted signal data input. RETRIEVE and REPAIR all non-network DTCs in the PCM. If no DTCs are present in the PCM, DIAGNOSE the observable symptom. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK the vehicle service history for recent service actions related to this module. This DTC can set due to incomplete or incorrect PMI procedures. If there have been recent service actions with this module, INSTALL As-Built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. REFER to Module Configuration . If there have been no recent service actions, INSTALL a new SOD-L or SOD-R to correct the failure to retain configuration data. |
| U3000:44 | Control Module: Data Memory Failure | GO to Pinpoint Test H . |
| U3000:45 | Control Module: Program Memory Failure | GO to Pinpoint Test H . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | GO to Pinpoint Test H . |
| U3000:48 | Control Module: Supervision Software Failure | GO to Pinpoint Test H . |
| U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test H . |
| U3000:4A | Control Module: Incorrect Component Installed | GO to Pinpoint Test H . |
| U3002:62 | Vehicle Identification Number: Signal Compare Failure | This DTC sets when the VIN stored in the SOD-L or SOD-R does not match the VIN that is broadcast on the network. CHECK the vehicle service history for recent service actions related to this module. If there have been recent service actions with this module, INSTALL as-built data from Professional Technician Society (PTS) following scan tool instructions under Module Programming>As-Built. REFER to Module Configuration . If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. Side Obstacle Detection (SOD) Module . |