Reversing Lamps
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1277:11 | Reverse Lamp: Circuit Short to Ground | GO to Pinpoint Test AA . |
| B1277:15 | Reverse Lamp: Circuit Short to Battery or Open | If the lamp is inoperative, GO to Pinpoint Test AA . If the lamp is always on, GO to Pinpoint Test AC . |
| U1000:00 | Solid State Driver Protection Actived-Driver Disabled: No Sub Type Information | The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test. |
| U3000:49 | Control Module: Internal Electronic Failure | The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other DTCs first. After the cause of the concern is corrected, Refer to BCM Hardware Testing .. |
| All other DTCs | - | REFER to the DTC Chart in Multifunction Electronic Modules . |