LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2016 >> Fusion Energi Titanium >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Control System) >> Injector >> Repair procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair procedures: Removal

WARNING: This page is about a different car, the 2014 Hyundai Elantra GT and 2013 Hyundai Elantra GT. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line.

    (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE .

    CAUTION: When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.
  3. Disconnect the injector connector (A).
  4. Disconnect the fuel feed tube quick-connector (B).
  5. Remove the installation bolt (C), and then remove the delivery pipe & injector assembly from the engine.
    Fig 1: Identifying Fuel Feed Tube Quick-Connector And Injector Connector
    G09885939Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the fixing clip (A), and then separate the injector from the delivery pipe.
    Fig 2: Identifying Injector Fixing Clip
    G09885940Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals