Programming Memory Positions

NOTE: Memory positions can be stored at any time.

NOTE: Verify good battery condition before diagnosing the memory seat system. Poor battery condition may interfere with memory seat operation, even if vehicle starting is possible.

1.

Place the ignition to ON.

2.

NOTE: To program the Remote Keyless Entry(RKE) transmitter, refer to Handles, Locks, Latches and Entry Systems .

To set memory position(s) move the memory driver seat, memory exterior mirror (if equipped), memory adjustable pedals (if equipped) and memory steering column (if equipped) to the preferred position using the appropriate switch(es).

3.

NOTE: Input from the driver seat control switch, pedal adjust switch (if equipped), exterior mirror control switch (if equipped) and steering column control switch (if equipped) during memory programming will abort the operation.

NOTE: If other tones or chimes are being produced, the memory save tone will not be heard because it is one of the lowest priorities.

Press and hold a memory button (1 or 2) until a tone is heard (1.5 seconds). When the tone is heard, the memory programming is complete.

4.

Repeat the previous steps to program another memory position.