Driver Multi-Contour Seat Module [SCMG]
DTC INDEX
| DTC | Description | Action to Take |
|---|---|---|
| B146F:00 | Back Bladder System Electropneumatic Failure: No Sub Type Information | GO to Pinpoint Test T . |
| B146F:04 | Back Bladder System Electropneumatic Failure: System Internal Failure | GO to Pinpoint Test T . |
| B1470:00 | Cushion Bladder System Electropneumatic Failure: No Sub Type Information | GO to Pinpoint Test T . |
| B1470:04 | Cushion Bladder System Electropneumatic Failure: System Internal Failure | GO to Pinpoint Test T . |
| B1471:11 | Multi-Contour Seat Switch Input: Circuit Short To Ground | GO to Pinpoint Test T . |
| B1471:13 | Multi-Contour Seat Switch Input: Circuit Open | GO to Pinpoint Test T . |
| B1471:2A | Multi-Contour Seat Switch Input: Signal Stuck In Range | VERIFY there is no obstruction that may be causing the multi-contour seat switch to be stuck in a certain position. If OK, INSTALL a new seat control switch. REFER to Seat Control Switch - Front . |
| B1473:11 | Pump Driver: Circuit Short To Ground | GO to Pinpoint Test T . |
| U1000:00 | Solid State Driver Protection Actived - Driver Disabled: No Sub Type Information | DIAGNOSE any other related Driver Multi-Contour Seat Module [SCMG] DTCs first. CLEAR the DTCs. REPEAT the self-test. If DTC U1000:00 returns. INSTALL a new Driver Multi-Contour Seat Module [SCMG]. REFER to Multi-Contour Seat Module (SCMG/SCMH) |
| U2100:00 | Initial Configuration Not Complete: no Sub Type Information |
NOTE:
This DTC indicates PMI has not been done to a newly installed module or configuration data has been lost. CARRY OUT Programmable Module Installation(PMI) on the Driver Multi-Contour Seat Module [SCMG]. REFER to
Module Configuration
. REPEAT the self-test. If PMI is successful, the DTC will not be present. |
| U3000:49 | Control Module: Internal Electronic Failure | INSTALL a new Driver Multi-Contour Seat Module [SCMG]. REPEAT the self-test. |