Vehicles With Am/Fm/Cd/Sync/Touchscreen: FCIM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| U0155:87 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: Missing Message | GO to Pinpoint Test AG |
| U2013:63 | Switch Pack: Circuit/Component Protection Time-Out | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the FCIM self-test. If DTC U2013:63 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM) . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to an incorrect or incomplete FCIM configuration. Using a diagnostic scan tool, PERFORM the FCIM programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration - System Operation and Component Description . See As-Built Data. |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the FCIM self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR all Continuous Memory Diagnostic Trouble Codes (CMDTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CMDTCs). If DTC U3000:42 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM) . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AM |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AN |