Body Control Module (BCM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1249:12 | Start Button Illumination: Circuit Short To Battery | GO to Pinpoint Test F |
| B1249:14 | Start Button Illumination: Circuit Short To Ground or Open | GO to Pinpoint Test F |
| U1000:00 | Solid State Driver Protection Active - Driver Disabled: No Sub Type Information | The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). When this DTC is stored in the BCM, the output driver is disabled until the cause of the excessive current draw has been corrected and a successful self-test has been performed. ADDRESS all other BCM Diagnostic Trouble Codes (DTCs) first. After the cause of the concern has been corrected, CLEAR the Diagnostic Trouble Codes (DTCs) and PERFORM the BCM self-test. |
| U2010:11 | Switch Illumination: Circuit Short to Ground | GO to Pinpoint Test A |
| U2010:15 | Switch Illumination: Circuit Short to Battery or Open | If the non-networked illumination sources are inoperative, GO to Pinpoint Test A If the non-networked illumination sources are always on, GO to Pinpoint Test B |
| U3000:49 | Control Module: Internal Electronic Failure | The BCM has permanently disabled an output because an excessive current draw exists (such as a short to ground) that has exceeded the limits of what the BCM can withstand. ADDRESS all other BCM Diagnostic Trouble Codes (DTCs) first. After the cause of the concern has been corrected, INSTALL a new BCM. REFER to: Body Control Module (BCM) . |
| All other DTCs | - | REFER to: Body Control Module (BCM) . |