LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2017 >> Edge SE, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Warning Systems >> Side And Rear Vision System >> Removal And Installation >> Side Obstacle Detection Control Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Side Obstacle Detection Control Module: Removal

Side obstacle detection control module 

NOTE: This step is only necessary if the SODL or SODR is being replaced.
NOTE: This procedure can be used for all locations of the component.

  1. 1.

    Using a diagnostic scan tool, begin the PMI process for the SODL or SODR following the on-screen instructions.

  1. 2.

    Remove the rear bumper cover. REFER to: Rear Bumper Cover .

  1. 3.

    Remove the SODL or SODR.

    1. 1.

      Disconnect the SODL or SODR electrical connector.

    1. 2.

      Remove the SODL or SODR screws.
GFD17511Courtesy of FORD MOTOR COMPANY

  1. 4.

    If required. Remove the screws and the SODL or SODR bracket.
GFD17512Courtesy of FORD MOTOR COMPANY

Side obstacle detection control module bracket 

  1. 5.

    Remove the SODL or SODR.

  1. 6.

    If required. Remove the screws and the SODL or SODR bracket.
GFD17512Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals