| 41 |
This DTC sets if the collision mitigation by braking deceleration message checksum is invalid. Using a diagnostic scan tool, RETRIEVE and DIAGNOSE all CCM module DTCs. REFER to COLLISION WARNING AND COLLISION AVOIDANCE SYSTEM
. If no CCM DTCs are present, the DTC may be caused by an intermittent concern. SET the ignition to OFF. DISCONNECT and INSPECT all PCM and GWM electrical connectors and related in-line connectors for corrosion, bent pins, pushed-out pins and spread terminals. REPAIR as necessary. |
| 82 |
This DTC sets if the collision mitigation by braking deceleration message count is out of range. Using a diagnostic scan tool, RETRIEVE and DIAGNOSE all CCM module DTCs. REFER to COLLISION WARNING AND COLLISION AVOIDANCE SYSTEM
. If no CCM DTCs are present, the DTC may be caused by an intermittent concern. SET the ignition to OFF. DISCONNECT and INSPECT all PCM and GWM electrical connectors and related in-line connectors for corrosion, bent pins, pushed-out pins and spread terminals. REPAIR as necessary. |
| 86 |
This DTC sets if the CCM is requesting an external apply of the electric parking brake and the vehicle is not in static mode. Using a diagnostic scan tool, RETRIEVE and DIAGNOSE all CCM module DTCs. REFER to COLLISION WARNING AND COLLISION AVOIDANCE SYSTEM
. If no CCM DTCs are present, the DTC may be caused by an intermittent concern. SET the ignition to OFF. DISCONNECT and INSPECT all PCM and GWM electrical connectors and related in-line connectors for corrosion, bent pins, pushed-out pins and spread terminals. REPAIR as necessary. |