SONY Audio System: TCU
| DTC | Description | Action |
|---|---|---|
| B116C:04 | External SIM Cable/SIM Card: System Internal Failure | GO to Pinpoint Test AF |
| B1246:11 | GSM (Group System for Mobile) Antenna: Circuit Short To Ground | GO to Pinpoint Test AF |
| B1246:13 | GSM (Group System for Mobile) Antenna: Circuit Open | GO to Pinpoint Test AF |
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test AG |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test AI |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test AK |
| U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | GO to Pinpoint Test AP |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to incomplete or incorrect PMI procedures. CHECK vehicle service history for recent service actions related to the TCU. If there have been recent service actions with this module, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. Refer to: Module Configuration - System Operation and Component Description . If there have been no recent service actions, INSTALL a new TCU to correct the failure to retain configuration data. Refer to: Telematics Control Unit (TCU) Module . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to incomplete or incorrect PMI procedures. CHECK vehicle service history for recent service actions related to the TCU. If there have been recent service actions with this module, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. Refer to: Module Configuration - System Operation and Component Description . If there have been no recent service actions, INSTALL a new TCU to correct the failure to retain configuration data. Refer to: Telematics Control Unit (TCU) Module . |
| U3000:04 | Control Module: System Internal Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:04 is retrieved again, INSTALL a new TCU. Refer to: Telematics Control Unit (TCU) Module . |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new TCU. Refer to: Telematics Control Unit (TCU) Module . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:04 is retrieved again, INSTALL a new TCU. Refer to: Telematics Control Unit (TCU) Module . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AS |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AT |