| B10AB:06 |
Remote Keyless Entry Synchronization: Algorithm Based Failures |
GO to Pinpoint Test AL
. |
| B10D7:31 |
PATS Key: No Signal |
This DTC sets during the RFA module self-test if 2 valid programmed passive keys are not detected inside the vehicle. CHECK each passive key individually to see if it operates the vehicle. If 2 valid programmed passive keys are not present inside the vehicle, DISREGARD this DTC. |
| B11CA:01 |
Driver Door External Antenna: General Electrical Failure |
GO to Pinpoint Test AP
. |
| B121A:11 |
Keypad Illumination Output: Circuit Short To Ground |
GO to Pinpoint Test AJ
. |
| B121A:15 |
Keypad Illumination Output: Circuit Short To Battery Or Open |
If the keypad illumination is inoperative, GO to Pinpoint Test AJ
. If the keypad illumination is always on, GO to Pinpoint Test AK
. |
| B121B:11 |
Keypad Input Switch: Circuit Short To Ground |
GO to Pinpoint Test AI
. |
| U201F:31 |
External Receiver: No Signal |
GO to Pinpoint Test AL
. |
| All other DTCs |
- |
REFER to
Multifunction Electronic Modules
. |