| B1115:11 |
High Mounted Stop Lamp Control: Circuit Short to Ground |
For Expedition, GO to Pinpoint Test AE
. For Navigator, GO to Pinpoint Test AD
. |
| B1115:15 |
High Mounted Stop Lamp Control: Circuit Short to Battery or Open |
If the lamp is inoperative, GO to Pinpoint Test AE
. If the lamp is always on, GO to Pinpoint Test AF
. |
| B132B:11 |
Left Stop/Turn Lamp: Circuit Short To Ground |
GO to Pinpoint Test AE
. |
| B132B:15 |
Left Stop/Turn Lamp: Circuit Short To Battery or Open |
If the lamp is inoperative, GO to Pinpoint Test AE
. If the lamp is always on, GO to Pinpoint Test AF
. |
| B132C:11 |
Right Stop/Turn Lamp: Circuit Short To Ground |
GO to Pinpoint Test AE
. |
| B132C:15 |
Right Stop/Turn Lamp: Circuit Short To Battery or Open |
If the lamp is inoperative, GO to Pinpoint Test AE
. If the lamp is always on, GO to Pinpoint Test AF
. |
| C0040:12 |
Brake Pedal Switch "A": Circuit Short To Battery |
GO to Pinpoint Test AF
. |
| U1000:00 |
Solid State Driver Protection Actived-Driver Disabled: No Sub Type Information |
The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test. |
| U3000:49 |
Control Module: Internal Electronic Failure |
The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other DTCs first. After the cause of the concern is corrected, BCM Hardware Testing
. |
| All other DTCs |
- |
REFER to the DTC Chart in
Multifunction Electronic Modules
. |